My question is regarding a threading process. There is 100% inspection for go/no go check and about 5% rejection/rework. The batch size is 5,000 nos and is completed in 3 days of production. Two such batches are produced in a month.
What type of control chart should be used to monitor the process? How should the process capability be calculated in this case?
The type of control chart first depends on what type of data you are measuring. If you are doing go/no go then you are limited to a “P” chart or a “C” chart. A “P” chart looks at % good (or bad). A “C” chart looks at the number of defects found.
If you are measuring thickness or strength, (something that can be measured), then you can use a X-bar/R chart or an X-bar/S chart depending on many samples are taken.
That is the simple answer; part of this depends on how you are taking samples and how often. If samples are taken at the start and the finish, then I would probably recommend the “P” chart.
If you can measure throughout the manufacturing process, and you look at the type of defects, then I recommend a “C” chart.
Ideally, if you can get measurement data, you are better off with the X-bar/R or the X-bar/S charts. These tend to be better predictors and it is easier to calculate capability.
With the capability for the go/no go data, you can get % defective, (or % good) and multiply that by 1,000,000 to get your capability estimate in defects per million.
SVP Process Design Manger, Process Optimization
Bank of America
ASQ Fellow, CQE, CQA, CMQ/OE, CSSBB, CSSMBB
Fort Worth, TX
Additional ASQ resources:
The Shewhart p Chart for Comparisons
by Marilyn K. Hart and Robert F. Hart